Digiprog3 Blue Screen Solution via Our Bluescreen Repair Chip
1. For those customer who buy digiprog3 update software from us,
then digiprog3 is bluescreen as they do not pay enough attention for details or other reasons,
you can try the following solution:
a. Buy a programmer, or through other ways to write “digi1.bin” and “digi2.bin”
which are in the update software we send to you to the following two chips.
2. If you do not know how to do for the first solution ,please check this second solution:
If you meet this problem, pls contact the customer service to get bluescreen repairchip for free, we will ship it to you via post. Then you can do as follows to solve the problem.
1. Take off the fly cable between C30 and X1
2. Take off the IC on the X1
Replace the old IC with our new IC (bluescreen repair chip)
3. Connect the fly cable as the original situation
Note: the original point of the IC is on the upper left corner, against C30.
(Red circled place is chip pic of STC15F: 10W H85330 8AB )
2. If you do not know how to do for the first solution ,please check this second solution:If you meet this problem, pls contact the customer service to get bluescreen repairchip for free, we will ship it to you via post. Then you can do as follows to solve the problem.
1. Take off the fly cable between C30 and X12. Take off the IC on the X1
Replace the old IC with our new IC (bluescreen repair chip)
3. Connect the fly cable as the original situation
Note: the original point of the IC is on the upper left corner, against C30.
(Red circled place is chip pic of STC15F: 10W H85330 8AB )
